Automatic Pyrolysis Plant
automatic pyrolysis plant
Qzone WeChat Facebook Twitter Print Favorites Pinterest LinkedIn AddThis 0Share
|Code:||*(marked *should be filled)|
Raw material :
1.Waste rubber tire, waste plastic, waste rubber products, etc.
2.Industrial mixed waste plastic, allowing dozens of waste existing
at the same time (such as PP, PE, PVC mix together etc).
3.Waste oil:waste diesel, lube oil, engine oil, waste oil residue,
mazut, tar oil, wax oil, waste crude oil etc.
4.Waste cable cover.
5.Waste PMMA(methyl methacrylate)rebirth.
6.Drainage oil, acid oil.
1.Put raw material into reactor by auto feeder, then close feeding
2.Make reactor rotate clockwise0.4r/min.
3.Burned the fuel material (coal, wood, natural gas or oil) in the
furnace. Reactor will be slowly heated, when the temperature reach
around 80℃, oil gas will come out.
4.The oil gas will through catalyst chamber and condenser
pipe,getting to the water oil separator.Some water of the tyres
will sink to the bottom,and the oil will float on the water.Then about 60% oil will flow to the first oil tank.
5.The other gas will go to cooling system,it through slowly and
have a good recycle in horizontal condenser.Then we will get about
40% oil flow to the second oil tank.
6.Some incondensable gas which can’t cool down will be get to the
anti-back fire device,then it will be recycled to the heating
system,used to heat reactor which can save your energy. Only the
first 2 hours use energy for heating. After the first 2 hours
mainly use gas, little energy is OK.
7.When the temperature get to about 300℃,there are no tyre in the
reactor,and the oil will come out over.At this time,we will stop heating,when the temperature fall down to
100℃- 150℃. Then open the door of carbon black discharging
system,and make it rotate anticlockwise, the carbon black will get
to the pool automatically.
8. After discharging carbon black,open the vacuum pump device.Release
the air inside the furnace,avoiding to catch fire.
9.When the tempera