The device is a mixture of new generation equipment for vacuum
drying plant digestion and absorption of foreign similar products
developed; the body of the device of vertical static, internal
heating ribbon circular stirring lifting movement, the material
into the cavity after drying by jacket and mixing ribbon of
material contact heating, the material is ordered with screw stir,
flip, lifting, falls off, make the material constant contact with
the heating cavity wall and forced heat exchange, solvent heated
and volatilized by pumping in a vacuum state, so as to achieve the
purpose of rapid drying.
O equipment and material contact parts are made of "GMP" material.
In the process of feeding, drying, mixing and discharging, O
equipment has no contact with the outside air, no leakage, no dead
The design, fabrication and inspection of the O equipment chamber
shall be carried out in accordance with the requirements of the
The o rotating joint adopts the double end face dry mechanical seal
which is required by GMP, and no foreign object falls.
The o cavity and the mixing paddle are provided with a heating flow
passage, and the mixing paddle is orderly and uniformly provided
with the heat exchange with the animal material, and the heating
area is large.
O in the drying process, the material is not hung and the wall is
O and material contact parts finish; Ra = 0., 4um (surface
passivation or electrolytic polishing)
O set online sampler.
O set top corner back blow valve.
- transmission - -
O adopts bevel gear reducer and energy saving motor
O employs silicone based food grade lubricants
- sealing - -
O on the cavity cover and the rotating blade with double end
mechanical seal is equipped with dry sump, with wells. The machine
is equipped with an on-line CIP/SIP and nitrogen leak detection
All sealing rings and pads of O equipment are GMP approved
The inner cavity can be sterilized for 30-40 minutes in the steam
of 121 DEG C, and the top is equipped with 3 sanitary stages, and
the 360 degree rotating spray ball is quickly installed to ensure
the cleaning of the upper cavity and the lower chamber
Water injection cleaning of body.
on line CIP/SIP of discharge valve
the sampler has an online CIP/SIP interface
Flange joint ring gap with CIP/SIP interface
The filter is CIP in the dryer after WtP
- adaptability - -
The thermo sensitive sterile grade, in the dry mixing process shall
not be exposed to air and gas not to leak the material.
containing flammable and explosive materials of different solvents.
high requirement mixing of various materials.
- productivity - -
Equipment maximum charge is 70%, minimum 8% (total volume
- Filter - -
The filter is made of 316L stainless steel sinter net, and the
filtration accuracy is l0-50um. (customer fixed) filter area is
large, no peeling, and can be online CIP and online nitrogen
- Sampler - -
using GMP approved materials, vacuum sampling, pressure balancing,
no peeling, no dead ends, and on-line CIP/SIP.
- discharge valve - -
Homemade non friction gas seal hemisphere valve, open angle
control, no pollution, smooth discharge, can be in CIP/SIP.
- control systems -
Design and manufacture according to GMP requirements
Man-machine field operation interface
DCS communication control
Remote device communication monitoring
temperature and pressure on-site display remote transmission
Practical temperature measurement and infrared measurement and
- Technical Support -
Verify the full set of documents according to URS's equipment
DQ (design con