1, The product benefits
CPY-2-type fume separator with carbon steel or stainless steel,
high efficiency, durability, resistance is small, beautiful,
degreasing effect is good, low noise, can be up and down to
install, easy installation.
The kitchen cooking fumes generated in the process of suction under
negative pressure in the fan into the gas-collecting hood, through
the air tube into the fume purifiers and fans, and then through a
discharge air duct.
Additives and the whole exchange by degreasing spray system so that
the cycle of soot over time exchange of soot in the oil composition
will be decomposed to make it into a liquid discharge through the
grease trap, the gas is treated to achieve "emission standard of
cooking fume" .
1. CPY-2 series fume purifier set the current domestic dry and wet
treatment of the two kinds of advantages, soot collected for
cleaner air through the air inlet, through the liquid atomization
spray, absorption, filtration to purify fumes, oil-water
separation. The environmental protection departments test the
concentration of soot emission removal efficiency of 94%, exceeding
the national regulations CWPB5-2000 (75% standard).
2. After treatment, the exhaust gas purifier tasteless, can be
directly discharged. Back to the cycle of oil and water tanks,
water tanks regularly as long as the oil slick artificial fishing
above to go to separate, (plus ancillary equipment can be
automatically separated). Therefore does not cause pollution of the
two. And supporting fan noise enclosures, silencers, to prevent
3. In order to achieve the best purification results, the user must
use the stove according to their actual amount of soot collected to
calculate cover an area, and then use the appropriate cleaner air
volume handled M3 / H model.
4. Fume purifier is usually installed on the roof. Such as in the
following (indoor or outdoor) the need to have a certain position,
or a certain distance clearance.
5. As the use of units in different situations, so the actual
situation on-site factory can design, processing, installation.
6. Fume collection of cover, air duct should be designed based on
usage configuration. Such as the user's own processing factory must
comply with the corresponding parameters of soot purifier model
provisions dealing with wind.