Each ZipWall Kit 20 package (KT20) contains two 20 foot Spring
Loaded poles (SLPs) and accessories for each pole. The Kit 20 is
ideal for creating dust barriers where ceiling heights are up to
20’. Importantly, you can do this without the use of tape or
staples, ladders, hydraulic jacks or scaffolding.
Consider this example: A 60 foot long, 19 foot high barrier that
takes 9 hours to complete with conventional methods. It also
requires an expensive hydraulic jack to raise the barrier sheeting.
With the ZipWall system, the same barrier can be completed by two
people in about 10 minutes without a hydraulic jack.
What’s more, no tape means no costly repairs to painted surfaces.
The Kit 20 poles extend from 5’2” to 20 feet. Poles should be
placed every 8' to 10' or closer if there is a lot of air movement.
The ZipWall Dust Barrier System is patented and has many advantages
over conventional methods. The twist-locking pole lets you raise
the sheeting without a ladder. The non-skid, non-marking material
at the top grabs the ceiling, while the non-skid GripDisk under the
foot keeps the pole locked in position at the floor. Spring Loading
lets you lift the pole to tuck the sheeting underneath for easy
setup. It also maintains constant tension on the barrier, to
compensate for movement at the ceiling or at the floor if the poles
are bumped, or if there is a lot of air movement.
All ZipWall poles are ideal for dropped ceilings. Spring Loading
automatically adjusts the pole height to compensate for any
movement of the grid during setup. Just place the poles so the tops
push against the grid, then follow the grid until you’ve contained
Kit 20 poles can accept any plastic or cloth sheeting up to 8 mils
thick and can support up to 110 lbs. Kit 20 poles work with all
ZipWall accessories including: Foam Rails, Side Clamps and self
adhesive zippers and more.