1, can be wet base surface construction.
2, can be used for the positive side and negative surface water.
3, water resistance, moisture resistance, excellent resistance to
4, strong paste, slurry of cement-based active ingredients can
penetrate the surface of the pores, and micro-cracks within the
surface layer of dense polymer waterproof membrane.
5, the slurry dries without protective layer of mortar to do direct
6, non-toxic, harmless and environment-friendly products.
Base surface treatment:
1, the base surface to be strong and smooth, clean, no oil, no
concrete release agent thereon.
2, the yin and yang, rounded corners make suggestions or diamond.
3, the base oil for a surface application of 10% sodium hydroxide
solution to scrub, then rinse with water.
4, for hollowing, loose base surface, tip off the projections
should be used to eradicate and polymers (interface treatment
agent) to repair the cement mortar.
1, in the dry surface of the base construction should be preceded
by wet-based waterproof coating surface water subject to ignorance,
if the base surface moist but not that water can be directly
2, according to the product mix, the first emulsion into water and
spices in mixing bucket, after adding the powder using electric
blender to mix evenly, let it rest 10 minutes and then stir until
the mortar until the powder-free.
3, using brush or roller brushing the paste evenly on the base
surface of the plasma, if the bubbles when brushing, brushing the
gas discharge should be repeated, and careful not to leave any
brush or leakage defects.
4, the first cream finish brushing should wait until dry solid pulp
(about 2 hours), then brushing the second slurry paste, the first
and the second should be perpendicular to the direction of
5, After 24 hours the waterproof layer dry completely before
entering the construction of other solid cover.
1, the air humid, poorly ventilated areas, ventilation should be
used to speed up the waterproof coating film, for example, sealed
drinking water tank or basement.
2, the completed waterproofing layer in the absence of the
protective layer before, without iron, nails, steel scaffolding
with water chestnut in a waterproof layer of heavy construction or
stacked, so as not to damage the waterproof layer.
3, is strictly prohibited to wear high heels or shoes with a small
construction site into the waterproof layer, so as not to damage
the waterproof layer.
4, cream pulp in the construction process should be maintained
intermittent stirring to avoid precipitation.
5, is strictly prohibited on rainy days or at 5-40environment
outside of the construction.
Store in a cool dry place, unopened powder can be stored for 12
Use area: 18 ~ 22M2 / set (a powder containing 9KG pulp +25 KG)