30ft winch up telescopic mast aluminum telescopic lighting mast 9
meter crank up mast antenna mast
Telescoping Aluminum Mast
For WiFi, Portable Antennas, Elevated Photos
Emergency Response Antenna Systems, Restricted Space Antennas -
Elevated Photography - Weather Instruments - WiFi Site Surveying -
End Zone Cameras
Our best-sellingpush-up pole is made of the highest quality
aluminum and built to last. Extremely portable but ready to provide
years of permanent service too!
light weight for easy carrying and perfect for temporarily
supporting antennas. More versatile than fiberglass or plastic
masts and particularly useful when a lightweight metal mast is
required.Tube wall thickness is2mm and heavy-duty thumb nut
compression clamps make for quick and easy adjustment of individual
You can raise any section by any amount to get the exact height and
rigidness you need! When securely mounted at the base and with most
lightweight items attached, guying is not usually necessary.
However, guying is always recommended.
The most frequent question we are asked is "How much weight will
this mast support?" The answer is... It will depend entirely on
what you mount on it, how it is mounted at the base, if guys are
used and how you plan to extend the mast with the load attached.
Our own personal, unscientific experience has shown 5 to 10 pounds
of vertical weight is reasonable. Keep in mind, this is vertical
weight and wind and/or off-center mountings may cause the mast to
sway or flex. Once again, guying and a good base support is highly
Used in conjunction with our matching mounting brackets, this mast
(portable light weight) is IDEAL for permanent mounting on RV's,
buildings or posts! The ability to raise and lower it quickly means
this mast can stay mounted all the time. For portable applications,
we have matching tripods and drive-on tire mount options available
too. See our other listings for more info on these items!
Spare parts are available but rarely needed!
- 3 to 15m full extended models
- Car suitable transport length
- Hand push up
- Max 80mm Diameter Bottom Section -
- 25mm Diameter Top Section
- Aluminum 6063 tube 2mm thickness
- Stainless steel clamp fast fasten, without tool
- COMMERCIAL QUALITY
Usually these masts require a flat or socket wrench, with the quick
release clamps you can raise and lower the masts without any tools.
Even with limited space these quick clamps can be easily used,
because the lever can be adjusted at any position. Just pull out
and release the lever, the strong spring latches the lever at the
The mast can be extended to any length and securely locks into
place by means of a massive clamp. The maximum allowed extended
length is marked by a color ring approx. 20cm before the end of
each tube. There is no fixed stop which makes it advisable to
approach the marking slowly when extending the telescopes.
These masts are ideally suited for portable applications due to the
low weight and the telescopic mechanism. When setting up the mast
please pay special attention to the clamping length; the clamping
length of the mast must be at least 1/6th of the extended length,
or at least 1 meter at the minimum. When extending the mast more
than 6 meters measured from the uppermost clamping point additional
guys are mandatory.
The tubes are made of weather-proof aluminum alloy. The tubes are
tapered by 5 mm and the tube thickness is 2mm. Please refer to the
following table for weight and dimensions. The stated additional
forces refer to a horizontally applied force at the tip of the
extended mast - without guys and a mast clamping length of 1/6th.
The calculation includes the inherent load at a wind speed of
50km/h (which is equivalent to a wind force of 7).
also we can produce according to clients special requests, and can