Surface of heating board is grinding, the width of heating board is
600mm, the heating board is made of container board, according with
the first class national pressure vessel standard, and provide
pressure vessel certificate and inspection certificate.
Heating board has multi sections to control the temperature,
equipped device of temperature display.
Leftright corrective adjustment of upper transmission belt
automatic adjustment, upper transmission belt consists of 2 sets of
tension system that are pneumatic adjustment
Lower cotton belt adopt S type manual correcting tensioning
structure, concise and practical, with one set of pneumatic
fine-tuning type device.
Surface of driving roll is attached with wear-resisting rubber, add
assure to output paperboard smooth
Driving parts adopt independent transmissiont parts, wheel gear is
made of ZG-500# cast steel, and wheel gear adopt oil-immersed
Electrical components adopts global famous brand, the device
working stably and operate reliable
Main driving motor adopt frequency conversion energy-saving motor,
low speed and big torque, wide speed-adjusting range, reliable to
use and easy to maintain.
Main frame adopt high-intensitive national Standard sections, firm
structure, beautiful exterior, suitable to work in high speed
v Hot plate’s pressing roller adopts pressing plate type, whole
part is controlled by hydraulic lift and down.
Upper belt equipped with air bag to rectify a deviation, the down
belt equipped with tension rectify the deviation device.
Cooling unit adopts concentrated suspension type pressing roller
design, transmission gear driving is oil-immersed sealed type.
Driving roller has center height, covered the herringbone abrasion
Max working width:1400,1600,1800,2000,2200mm
Operation direction: left or right
Max speed: 120-150m/min
Temperature requirement: 160-200 oC steam pressure: 0.8-1.3Mpa
Pneumatic pressure: 0.6-0.9Mpa
Pressure of hydraulic system: 6-8Mpa
Parameter of roll diameter:
Diameter of upper driving roll: ￠640mm
Diameter of lower driving roll: ￠640mm covered the abrasion
Diameter of front driving belt roll: ￠321mm
Diameter of back case-hardened driving roller: ￠215mm
Diameter of pressing roller: ￠70mm
Diameter of case-hardened carrier roll: ￠86mm
Diameter of upper belt tension roller: ￠130mm
Diameter of upper belt deviation-adjusting roll: ￠124mm
Diameter of lower belt tension roll: ￠1300mm
Diameter of lower belt carrier roll: ￠130mm