132kV Polymer Suspension Type Insulators Light Weight For
Dimensions and Characteristics of 132kV composite suspension
|Figure. No||Model||Rated Voltage||Specified Mechanical Load||Section Length||Minimum Creepage||Full-Wave Impulse Withstand Voltage (Peak)|
1 Min Wet Power Frequency Withstand Voltage
|Weight (for Reference)|
1, 132kV suspension tension insulators are widely used in overhead
transmission lines and substations
2, Dead end fittings are up to the requirements from the clients,
usually we use ball, socket, tongue, clevis for suspension
insulators with forged steel or cast steel. The dimensions and
coupling size can be exactly according to the specification
requirements from the utilities.
3, The silicon rubber color of the insulators are also up to the
requirements from the clients and all the silicon rubber materials
past 5000 hours aging test silicon content test and hydrophobicity
4, ECR core rods are used in all the insulators, so we can
guarantee a very good mechanical strength and anti-acid pollution
performance for the insulators.
5, All our insulators were type tested and design tested in
accordance with IEC61109, maximum RIV is 100µV when tested at 1MHz
and10% over nominal line ground voltage for indicated system
6, All the 132kV suspension or tension insulators are designed with
one corona rings
1, 132kV EHV overhead transmission power lines.
2, 132kV EHV substations
Features/ advantages :
1. Good performance of hydrophobility
3. High mechanical strength
4. Small volume
5. Light weight
6. Can replace the porcelain ones because of the good anti
pollution, convenient installation
and free from maintainance performance.
1. We offer the best solution and products to fulfill the buyers'
2. We can arrange technicians to install the equipments and train
your staff on site.
3. Anytime, we provide considerate technical consultation.
4. Prompt reply for your inquiry and feedback.
5, OEM service is also available with us.